File Server Failover Cluster Part 2 - Installing and Configuring Failover Cluster

In Part1, I installed and configured ISCSI Target Server. Then configured iSCSI initiators. Now we can start installing Failover Cluster Feature on Node1 and Node2.

On FileServer01 and FileServer02 do the following steps:

Server Manager > Add Roles and Features > Role Based or Feature Based installation > Select the server> Do not select any roles and click Next

 

 

On Feature Page, Select Failover Clustering. CLick Add Features button when it pops up.

 

 

And click Install.

 

 

IMPORTANT: After we completed Installing Failover Feature, we need to take Online  and initialize the disks only on 1 of the Cluster Nodes but not on both Nodes. (Do this for Disk1 and Disk2). Do the following only on Node1.

 

 

Then create partition on both disks by right clicking on disks and chosing "New Simple Volume".

 So we created 2 partitions on Node1, named Quorum and FS Data.

 

On Node 2, Our disks are in Offline state

 

FAILOVER CLUSTER CONFIGURATION:

Let's start configuration of Failover Cluster. Make sure Both Nodes Windows Update Service is Running and they are patched with the same updates.

 

1. Validating The Nodes For Clustering:

Do the following steps on only Node1

Server Manager > Tools >Failover Cluster Manager> Select Validate Configuration> Click Browse and add the servers

 

Select "Run all tests" > On Confirmation Window click Next> 

 

 

Click View Report and make sure, All test succeed (with or without warnings). Click Finish.

 

2. Creating The Clustering:

On Failover Cluster Manager > Choose "Create Cluster"

 

Select both Nodes

 

Give a name for your cluster and assign a Cluster IP for your cluster like below

 

Click Next

(If you tick on the checkbox, it adds all the eligible disks to your cluster or you can add them later as well.)

 

 You can view the report or just click finish button to complete the wizard.

 

During the Cluster Creation, an computer object on Active Directory and DNS A Host record automatically will be created. 

 

On Failover Cluster Manager check the Nodes, Disks, Quorum Disk and Networks to see everything in place and working properly.

Check Nodes

 

Check Disks

 

 

How to change Quorum Disk?

If you need to change your quorum disk just do the following steps.

Right Click the Cluster> More Actions > Configure Cluster Quorum Settings> Click Next > 

 

Select Quorum Witness >

 

Select "Configure a disk witness" radio box

 

 

Select the disk you want use as the quorum witness disk

 

Check Networks as well. I have 3 networks. Open their properties and give each one a descriptive name for easier management.

Domain Network should be accessible to other networks

 

ISCSI Network should be totaly isolated

 

 

HeartBeat Network allows cluster network communication but clients are not allowed to reach this network

 

 

3.Adding Role on Failover Cluster:

Failover Cluster is working just fine.  Now we can add a role. Right click Roles and choose "Configure Role"

 

Select the Role you want

 

Select "File Server for general use"

 

 

The name you enter here will be dns name for this service. Go ahead and assign an virtual ip address for the service. In a Cluster, you might have multiple roles. Therefore the virtual ip you assign here will be used for that particular service.

 

 

Select the storage

 

 

Click Next and complete the wizard.

 

 

 DNS record for fileserver is created automatically and I can see my shares like this.

 

 

I wanted to see how many ping it losts to failover in my lab environment and it is only 1 ping. So, this is the end of this post. Thanks for reading.